Prompts are pre-built conversation templates that guide Claude through multi-step procedures. They set up context and provide step-by-step instructions for common workflows.
Available Prompts
Calibration & Setup
Prompt
Description
calibrate
Full SOLT calibration walkthrough
export_touchstone
Export S-parameters to .s1p/.s2p
Antenna Analysis
Prompt
Description
analyze_antenna
SWR, impedance, bandwidth analysis
visualize_radiation_pattern
Generate 3D pattern from S11
measure_antenna_range
Automated 3D pattern with positioner
import_pattern
Import external pattern files
Component Analysis
Prompt
Description
measure_component
Identify unknown L/C/R
analyze_crystal
Crystal parameter extraction
analyze_filter_response
Filter characterization
measure_lc_series
Series LC resonator
measure_lc_shunt
Shunt LC resonator
Cable & Transmission Line
Prompt
Description
measure_cable
Cable characterization
measure_tdr
Time domain reflectometry
Design
Prompt
Description
impedance_match
L-network matching design
compare_sweeps
Before/after comparison
Prompt Parameters
Most prompts accept parameters to customize the workflow:
calibrate
calibrate(
band="2m", # Ham band name or "custom"
start_hz=144000000, # Start frequency (overrides band)
stop_hz=148000000, # Stop frequency (overrides band)
points=101, # Sweep points
save_slot=0 # Flash slot for calibration
)
analyze_antenna
analyze_antenna(
band="2m", # Ham band name
start_hz=None, # Override start frequency
stop_hz=None, # Override stop frequency
points=101 # Sweep points
)
visualize_radiation_pattern
visualize_radiation_pattern(
antenna_type="dipole", # dipole, monopole, efhw, loop, patch, auto
